Drawer Pulls

I don’t own a lathe, so when I found out about this process for making a drawer pull using a drill press I was all over it.  I used a flat rasp, 3/8″ diameter rasp and a tenon cutter.  It was very easy to do and was actually pretty fun at the same time.

One Response to “Drawer Pulls”

  1. Randy says:

    Brian – Nice job with the videos. I wouldn’t want to have to make enough pulls for a dresser, but this would work for one or two. One addition thought on the 1/2 tenon cutter would be to drill a 1/2″ hole and use a section of dowel – just a thought.

Leave a Reply