Ebony Splines are In!

They are glued on the core side only and float in the breadboard end. I removed the excess ebony by using a flush trim router bit w/ over sized bearing to create the desired reveal. If chip-out were to occur at the routing stage I would be in deep trouble. Thankfully, everything went smoothly.

spline008

 

splines1

Tags:

2 Responses to “Ebony Splines are In!”

  1. Bartee Lamar says:

    Nice Job ! This is going to be a really nice piece.

  2. Brian says:

    Thank you!

Leave a Reply